dual operational amplifiers 1 description the lm358 consists of two independent, high gain, internally frequency compensated operational amplifiers which were designed specifically to operate from a single power supply over a wide range of voltages. operation from split power supplies is also possible and the low power supply current drain is independent of the m agnitude of the power supply voltage. application areas include transducer amplifiers, dc gain blocks and all the conventional op amp circuits. features package information wide range of supply voltages low supply current drain independent of supply voltage low input biasing current low input offset voltage and offset current input common-mode volt age range includes ground differential input voltage range equal to the power supply voltage dc voltage gain 100 v/ mv typ internally frequency compensation electrical characteristics at specified free-air temperature, vcc = 5 v (unless otherwise noted) lm358/ LM358M/ LM358Mmk parameter test conditions* min typ max unit v io vcc = 5 v to max, 25 3 7 mv input offset voltage v ic = v icr min, vo=1.4 v full range 9 v io average temperature coefficient of input offset voltage full range 7 v/ c l io vo=1.4 v 25 2 50 na input offset current full range 150 lio average temperature coefficient of input offset current full range 10 pa/ c i ib vo=1.4 v 25 -20 -250 na input bias current full range -500 v icr vcc = 5 v to max 25 0 to vcc-1.5 v common-mode input voltage range full range 0 to vcc - 2 v oh r l 2 k ? (n ote 1) 25 vcc-1.5 v high-level output voltage vcc = max, r l =2 k ? full range 26 vcc = max, r l 10 k ? full range 27 28 v ol low-level output voltage r l 10 k ? full range 5 20 mv a vd large-signal differential vcc = 15 v, vo=1v to 11 v, 25 25 100 v/mv voltage amplification r l 2 k ? full range 15 cmrr common-mode rejection ratio vcc = 5 v to max, v ic = v icr min 25 65 80 db k svr supply voltage rejection ratio ( ? vcc/ ? v io ) vcc = 5 v to max 25 65 100 db vo1 /vo2 crosstalk attenuation f=1 khz to 20 khz 25 120 db lo vcc = 15 v, 25 -20 -30 ma output current v id =1 v,v o = 0 full range -10 vcc = 15 v, 25 10 20 v id = - 1 v, vo = 15 v full range 5 v id = - 1 v, vo = 200 mv 25 12 30 a l os short-circuit output current vcc at 5 v, gnd at -5 v,vo=0 25 40 60 ma i cc vo - 2.5 v, no load full range 0.7 1.2 ma supply current (two amplifiers) vcc = max, vo = 0.5vcc, no load full range 1 2 ? all characteristics are measured under open-loop conditions with zero common-mode input voltage unless otherwise specified. ?max? v cc for testing purposes is 30 v. full range is 0 to 70 . note1 only for lm358 LM358M
dual operational amplifiers 2 pad location LM358M chip size: 0.8 x 0.95 mm 2 pad location coordinates coordinates, m pad n pad name pad size ( m m ) x y 1 #1 out 95 x 95 657 , 5 807 , 5 2 #1 in- 95 x 95 116 , 5 831 , 5 3 #1 in+ 95 x 95 116 , 5 660,5 4 gnd 95 x 95 116 , 5 475 5 #2 in+ 95 x 95 116 , 5 289,5 6 #2 in- 95 x 95 116 , 5 118,5 7 #2 out 95 x 95 657 , 5 142 , 5 8 v cc 95 x 95 687,5 474,5 6 5 4 3 2 1 8 7 LM358M
|
